They needed a trade show backdrop to fit into an existing aluminum structure, and it needed to be printed on both sides. In addition, everything slides into a slot on the frame the way a sail goes into a mast.
We printed the center and side pieces of the banner, and then sewed a 1/4″ rope into the hem on the top and bottom. It was a bit of a trick to get everything printed on both sides and hemmed with the rope and in the right size, but we did it! As you can see from the picture, everything worked out very nicely.
This kind of project presents it’s challenges, and we are very lucky to have a talented group in the vinyl department! They can think through how to make something that strays from the ordinary, and give you great results!